STONE Adhesive 1109
Stone Adhesive is a high polymer modified & highly flexible adhesive with enhanced properties of slip resistant, extended open time & excellent bond strength which is necessary for fixing large format tiles/ natural stones & slim tiles on vertical & horizontal surface for indoor as well as outdoor application, especially in external conditions & on substrates subject to deformations/ vibrations.
- Sag Resistant formula – for hassle-free application on vertical walls.
- Water & shock resistant – suitable for wet areas & commercial floor too.
- Sustains heat ageing – Idea for external & high temperature applications.
- Highly deformable adhesive – sustains substrate vibration.
- LowVOC-for healthyliving
Benefits
- Highly Polymer modified - excellent bond strength at different conditions
- Extended open time - suitable for large format & external condition
Coverage Estimates
- Pack Size - 20 kg
- Approx. 2.5 kg/m² using a 6mm
- x 6mm square notch trowel
How to apply
Substrate:
The surface to be covered with Ceramic/Vitrified tile shall be sound and confirm to good design, rigid, clean and free of dirt, oil, grease, curing compounds, form release agents or loose plaster and paint. For economy the surfaces should be level and true with in:
- Walls-3mm in 2.5m
- Floors - 1.5mm in 1.0m
- If a plaster/leveling mortar bed is applied, ensure that it is cured for at least 7 days to achieve proper strength before application of tile adhesive for installation of tile.
- Ensure the substrate is clean and free from impurities like dust, dirt, debris, oil, grease, curing agents, loose plaster etc.
- Dampen the wall before applying of thin set adhesive
- Clean the back of the tile for any dust or coating.
The products can be mixed by hand or slow speed electric drill mixer (less than 300 rpm).
Pour water in a clean container and then add PRIMO 1109 adhesive and mix until the mixture becomes creamy and sturdy. Do not over mix. Leave the mix to slake for 5-10 min and remix before use. Mix only sufficient quantity of adhesive for immediate need.
Approximately 1 bag of PRIMO 1109 with 5-6 Itrs of water. Adjust quantity of liquid to obtain proper consistency.
Installation:
Wet the surface and remove the excess water before applying the adhesive. The adhesive shall be applied with the flat side of the trowel using a scraping motion to work the material into good contact with the surface to be covered. Additional mortar is then applied with the notched edge of the trowel.
When installing large tiles, spread adhesive onto back of tile in addition to trowelling material over surface to be tiled. Select proper type of notched trowel.
- Thin Tiles upto size 300 X300 mm (1’X1′), use a square notched trowel of size 6mm X6mm to provide a total thickness of 3mm
- Large Porcelain Tiles upto 450 X 450 mm with ribs, use a square notched trowel of size 6mm X6mm and back butter the tiles
with the same adhesive to a thickness of 1-1.5mm to provide a total thickness of 4.5mm - Large Porcelain Tiles upto 600 X600 mm (2’X2′) with ribs, use a square notched trowel of size 6mm X9mm and back butter the
tiles with the same adhesive to a thickness of 1-1.5mm to provide a total thickness of 6mm
The most important standard to keep in mind is to insure that the piece of tile is completely bedded in the mortar or adhesive with 100% coverage.
Rear face of tiles (especially Porcelain tiles) should be cleaned with damp sponge to clean all the dust. Do not saturate in water.
Excess mortar on adhesive shall be cleaned from the surface of the stone with wet cloth or sponge while the mortar is fresh.