Primo Epoxy Adhesive
For attaching small- and large-format tile and stone to walls and floors, PRIMO EPOXY Adhesive is a three-part, highly durable, chemical-resistant adhesive. For fastening tile and stone to metal, glass, aluminum, plywood, etc. surfaces, it offers exceptional, long-lasting binding strength. PRIMO epoxy adhesive is suitable for both inside and exterior damp locations. Due to its chemical resistance, it can also be used in commercial installations that are located in chemically vulnerable regions, such as food processing facilities, commercial kitchens, dining establishments, high-traffic areas, and workshop spaces.
Benefits
- Excellent adhesion properties, tiles & stone can be fixed on surface like metal sheet, aluminum panels, glass, plywood etc
- Fixing Tiles & Stones on Ceilings & Elevated Structures
- Provides high strength and durable resistance
- Can be used on floor & Wall in Chemical Prone Areas
- Provides strengthat higher height level Where cement based adhesive has limitations
Coverage Estimates
- Pack Size - 5 kg., 10 kg.
- The consumption will vary depending on surface undulations
How to apply
Substrate:
The surface to be covered with Ceramic/Vitrified tile shall be sound and confirm to good design, rigid, clean and free of dirt, oil, grease, curing compounds, form release agents or loose plaster and paint. For economy the surfaces should be level and true with in:
- Walls-3mm in 2.5m
- Floors - 1.5mm in 1.0m
Installation:
Wet the surface and remove the excess water before applying the adhesive. The adhesive shall be applied with the flat side of the trowel using a scraping motion to work the material into good contact with the surface to be covered. Additional mortar is then applied with the notched edge of the trowel.
When installing large tiles, spread adhesive onto back of tile in addition to trowelling material over surface to be tiled. Select proper type of notched trowel.
- Thin Tiles upto size 300 X300 mm (1’X1′), use a square notched trowel of size 6mm X6mm to provide a total thickness of 3mm
- Large Porcelain Tiles upto 450 X 450 mm with ribs, use a square notched trowel of size 6mm X6mm and back butter the tiles
with the same adhesive to a thickness of 1-1.5mm to provide a total thickness of 4.5mm - Large Porcelain Tiles upto 600 X600 mm (2’X2′) with ribs, use a square notched trowel of size 6mm X9mm and back butter the
tiles with the same adhesive to a thickness of 1-1.5mm to provide a total thickness of 6mm
The most important standard to keep in mind is to insure that the piece of tile is completely bedded in the mortar or adhesive with 100% coverage.
Rear face of tiles (especially Porcelain tiles) should be cleaned with damp sponge to clean all the dust. Do not saturate in water.
Excess mortar on adhesive shall be cleaned from the surface of the stone with wet cloth or sponge while the mortar is fresh.
