WHITE STAR Tile Adhesive 555 P
Polymer modified white cement-based adhesive, suitable for fixing ceramic tiles for floors & walls in interior situations. Suitable for fixing ceramic tiles up to 6 mm bed thickness (can be extended up to 12 mm thickness in an area of limited extent).
Benefits
- Good Bond Strength
- Water Resistant
- Easy Mixing & Application
Coverage Estimates
- Pack Size - 20 kg
- Approx. 3 kg/m² using a 6mm
- x 6mm square notch trowel
How to apply
Substrate:
The surface to be covered with Ceramic/Vitrified tile shall be sound and confirm to good design, rigid, clean and free of dirt, oil, grease, curing compounds, form release agents or loose plaster and paint. For economy the surfaces should be level and true with in:
- Walls-3mm in 2.5m
- Floors - 1.5mm in 1.0m
Installation:
Wet the surface and remove the excess water before applying the adhesive. The adhesive shall be applied with the flat side of the trowel using a scraping motion to work the material into good contact with the surface to be covered. Additional mortar is then applied with the notched edge of the trowel.
When installing large tiles, spread adhesive onto back of tile in addition to trowelling material over surface to be tiled. Select proper type of notched trowel.
- Thin Tiles upto size 300 X300 mm (1’X1′), use a square notched trowel of size 6mm X6mm to provide a total thickness of 3mm
- Large Porcelain Tiles upto 450 X 450 mm with ribs, use a square notched trowel of size 6mm X6mm and back butter the tiles
with the same adhesive to a thickness of 1-1.5mm to provide a total thickness of 4.5mm - Large Porcelain Tiles upto 600 X600 mm (2’X2′) with ribs, use a square notched trowel of size 6mm X9mm and back butter the
tiles with the same adhesive to a thickness of 1-1.5mm to provide a total thickness of 6mm
The most important standard to keep in mind is to insure that the piece of tile is completely bedded in the mortar or adhesive with 100% coverage.
Rear face of tiles (especially Porcelain tiles) should be cleaned with damp sponge to clean all the dust. Do not saturate in water.
Excess mortar on adhesive shall be cleaned from the surface of the stone with wet cloth or sponge while the mortar is fresh.
